IECM 12.0 beta User Manual > Using the IECM > The IECM Interface > The Session Window > The Navigation Panel > Organization of the Navigation Panel > Technologies |
|
Inside each Program Area, the screens are grouped by Technology. In the old tab-style interface, technologies are in the row of smaller tabs beneath the Program Areas .
The CONFIGURE SESSION Program Area has no technologies, as none of its screens are technology-specific. The ANALYSIS TOOLS Program Area contains 2 technologies:
•Sensitivity Analysis
•Uncertainty
The list of technologies in the SET PARAMETERS and GET RESULTS program areas is different for each plant type. Technologies that do not contain any screens in the current configuration will not be shown.
The SET PARAMETERS and GET RESULTS Program Areas in a Pulverized Coal (PC) plant may contain the following technologies:
•Overall Plant
•Fuel
•Base Plant
•NOx Control
•Mercury
•TSP Control
•SO2 Control
•CO2 Capture, Transport & Storage
•Water Systems
•By-Prod. Mgmt
•Stack
•Life Cycle Assessment
The SET PARAMETERS and GET RESULTS Program Areas in a Natural Gas Combined Cycle (NGCC) plant may contain the following technologies:
•Overall Plant
•Fuel
•Power Block
•NOx Control
•CO2 Capture, Transport & Storage
•Water Systems
•By-Prod. Mgmt
•Stack
•Water Life Cycle Assessment
The SET PARAMETERS and GET RESULTS Program Areas in an Integrated Gasification Combined Cycle (IGCC) plant may contain the following technologies:
•Overall Plant
•Fuel
•Air Separation Unit
•Gasifier Area
•Sulfur Removal
•CO2 Capture Transport & Storage
•Power Block
•Water Systems
•By-Prod. Mgmt
•Stack
As an example, this illustration shows the technologies available under the SET PARAMETERS Program Area in a PC plant with the Typical New Plant configuration:
The SET PARAMETERS Program Area in a Typical New PC Plant
The SET PARAMETERS and GET RESULTS Program Areas typically have slightly different technology lists. In particular, Stack only appears in the GET RESULTS Program Area. The Stack module does not have any parameters, only results, so it is hidden in the SET PARAMETERS Program Area.
Copyright © 2023-2024 University of Wyoming. All rights reserved. Visit us at https://www.iecm-online.com/